Hi All,
I posted this over in emastercam, but unfortunately with not much luck.
So here goes...
We normally use a hand generated MS Word template for our set up sheets.
I've recently been playing with the Mill Set and have it nearly (as always!) as we want it. But...
How do I get it to sort tools in tool number order and stop duplicate tool calls?
We want
T1
T2
T3 etc.
Also, is there any way that it could open a MS Excel template, and output the different fields into specific cells?
I assume that it might be easier to do this and get things where we want them, rather than outputting to a Word template?
I have looked at the older version of X+ setup sheet, but didn't really like it.
I haven't looked at the one for X3 , as we haven't got round to migrating to that.
X4 is out in a month, so we'll have a look then, but for now the MILL.SET would do for what we want, if I can get it to work how we want!
Many thanks in anticipation,
Terry