Hi all!

How is everyone?

I'm Schneckster, from Birmingham. Electronics engineer by trade and looking to build my first CNC machine as a base on which to make parts for something a bit more ambitious.

I'm also looking for an algorithm for converting G-Code to stepper motor control so that I can build my own stepper motor controller. I know G-Code describes the movement the machine needs to make but it is turning that into pulses on a stepper motor that I don't know, particularly circular motion, etc.

So there you go. Thanks in advance for any help and advice I get from this forum, and I'll try to chip in with help and advice if I'm able.

Cheers,

Schneckster