Hi,
I have just received BobCad V23 Pro.
Being my first cam project on the system, I need some guidance.
The plan is to use "Z-level Rough" to rough out the cavity, followed by "Equidistant Offset" to clean up the part. The finish needs to be as good as possible. I want to use ball cutters for roughing and finishing. This means that the edges at the bottom of the cavity would be rounded, so to clean that up, I had planned to use a 3mm end mill. The snag is, I cannot figure out how to select the edges to form a profile.
Is there a more efficient way of doing this? It's going to take for ever to cut?
Thread: My First Project with V23 Pro.
Results 1 to 6 of 6
Threaded View
-
06-13-2009, 10:12 AM #1
Registered
- Join Date
- Jun 2009
- Posts
- 52
My First Project with V23 Pro.
Reply With QuoteSimilar Threads
-
My cnc project
By llilrex in forum DIY CNC Router Table MachinesReplies: 1Last Post: 11-06-2007, 02:17 AM -
What should I do for my project?
By DrewSmith007 in forum MetalWork DiscussionReplies: 1Last Post: 09-11-2007, 05:19 PM -
RC toy project
By JRoque in forum Hobby DiscussionReplies: 4Last Post: 12-30-2005, 08:49 AM -
Look what I can do! (First CNC Project)
By cp8071 in forum DIY CNC Router Table MachinesReplies: 7Last Post: 09-06-2005, 10:26 PM
Posting Permissions
