[bartL]

Hello,

I'm busy retrofitting my Hardinge HXL lathe with servomotors and TEK10 drivers. The system is running on 80Vdc and 10A max. A few weeks ago I already had this system running and did some testing with it. After that I removed the complete system to change the setup and complete the wiring.
Now this week I've tried to assemble the elektronics on the machine again
but without any results. As soon as I power up the system the red LED starts flashing. I've checked everything and it all seems to be ok. I got the 5V enable signal, the 12V on upper and lowerboard and the 80Vdc motor power input. Does anyone overhere has a suggestion what this problem can be?

Regards,
Bart

[Dirkos]

Hello,

The same happened to me, do you find out wat the problem was / is?

regards,

Dirk

[bartL]

Dirk,

I couldn't find the problem myself so I contacted CNCTeknix and they asked me to send the driver back for a check. There was a problem somewhere in the circuit and they fixed it without any costs! Good service!

Bart