My z axis resolver went out this afternoon, luckly I had a old motor with a good resolver the change only took a few mins and I know how to set it up so thats not the problem,

is there a setting I need to change for the tool changer? as you know when you replace a resolver you will have to turn the resolver to get it close to the indication marks. when you do a CS it will be close but off a few thousanths from were it was before the bad resolver. I assume this will effect the tool change height ?

where do I fix that? I know once before I had to go in and do something like that( tool change height got messed up) but it was 2 years ago and my memory is bad.

Thanks
Delw