585,754 active members*
3,944 visitors online*
Register for free
Login
IndustryArena Forum > MetalWorking > MetalWork Discussion > Integrex 200SY Question

Thread: Integrex 200SY Question

Results 1 to 1 of 1
  1. 07-02-2009, 04:31 PM #1
    tricmachine
    tricmachine is offline Registered
    Join Date
    Sep 2008
    Posts
    5

    Integrex 200SY Question

    Hi, I am trying to do a job using some longer stock. I took the plate off of the back end covering the spindle to slide the rod through that way. After I took the plate off I saw another plate bolted to the spindle with four screws. Can I take this plate off? Ive never seen one on my older machines and do not want to undo something that I can mess up.
    Attached Thumbnails Attached Thumbnails IMG_0351.jpg   IMG_0352.jpg  
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. integrex IG 300IVs
    By mazman in forum Mazak, Mitsubishi, Mazatrol
    Replies: 1
    Last Post: 06-06-2008, 06:34 PM
  2. Camware for Integrex 300-IV ST
    By Jaker in forum Mazak, Mitsubishi, Mazatrol
    Replies: 1
    Last Post: 04-24-2008, 07:04 PM
  3. Mazak Integrex 200 III St ISO/EIA
    By maramb in forum Mazak, Mitsubishi, Mazatrol
    Replies: 19
    Last Post: 11-28-2007, 09:41 PM
  4. Integrex IV help
    By Demon440 in forum Mazak, Mitsubishi, Mazatrol
    Replies: 8
    Last Post: 02-19-2007, 08:21 PM
  5. integrex 50 YB ISO Programming
    By Batman in forum G-Code Programing
    Replies: 3
    Last Post: 12-13-2006, 12:47 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules