We have a VF1 mill with the HA5C indexer. Is there any way to zero out the indexer to a different position. I indicated a part flat last night and it was aprox. 8 degrees off zero and I wanted to set a zero there but I could not figure out how,I know with the seperate control box it can be done but I'm not sure how to with the indexer wired directly into the machine.
Thread: question about 4th. axis
Results 1 to 3 of 3
-
07-01-2009, 01:51 PM #1
Registered
- Join Date
- Sep 2008
- Posts
- 10
question about 4th. axis
-
07-01-2009, 03:42 PM #2
Registered
- Join Date
- Mar 2008
- Posts
- 638
Does the "A" axis show up in the offset page?
If it does, zero out the part and press the "Part Zero Set" button.
-
07-01-2009, 04:13 PM #3
Registered
- Join Date
- Feb 2009
- Posts
- 64
Offset
Additional axes are set to work offsets the same as the traditional x,y,and z axes.
Reply With QuoteSimilar Threads
-
Rookie Question...3 axis vs 4 axis controller
By Ferrari2007 in forum DIY CNC Router Table MachinesReplies: 3Last Post: 09-14-2009, 02:04 AM -
x axis question
By nasrace10 in forum Commercial CNC Wood RoutersReplies: 0Last Post: 02-20-2009, 02:12 AM -
Question about Z Axis
By jfunk56 in forum DIY CNC Router Table MachinesReplies: 2Last Post: 05-03-2008, 02:10 PM -
Z axis question
By Ric_A in forum Machines running Mach SoftwareReplies: 2Last Post: 06-05-2006, 01:27 PM -
5 axis question
By turmite in forum Mechanical Calculations/Engineering DesignReplies: 50Last Post: 11-06-2005, 11:34 PM
Posting Permissions
