Hi all,
I have had alot of sucess so far in my setup. But I am having a problem with the homing sequence. I am looking for where and how you modify this....
Jim
Hi all,
I have had alot of sucess so far in my setup. But I am having a problem with the homing sequence. I am looking for where and how you modify this....
Jim
Enhanced Machine Controller (EMC)"
You will need to do a search and regester etc.
Good bunch there!
Cal
Jon, Ca,
Thank You
I have now resolved my problem..... The homing now works... On to the next problem..
Jim
You might get better results with one of these contact methods to the EMC community.
http://www.linuxcnc.org/content/view/4/8/lang,en/
John