585,875 active members*
4,073 visitors online*
Register for free
Login
IndustryArena Forum > MetalWorking Machines > Uncategorised MetalWorking Machines > Error 414 Z-axis error detect servo alarm

Thread: Error 414 Z-axis error detect servo alarm

Results 1 to 2 of 2
  1. 07-09-2009, 02:23 PM #1
    andywids
    andywids is offline Registered
    Join Date
    Jan 2009
    Posts
    6

    Exclamation Error 414 Z-axis error detect servo alarm

    Hi,

    I'm using a Hwacheon Ecomil 65V with Fanuc 18M brain. Upon startup, the oil cooling unit does not turn on as it normally should and I'm given an error "414 Z-axis error detect." I am not able to move the machine or start the spindle. I have had this problem before and have resolved it previously by filling the hydraulic oil reservoirs as they were low. The oil has been filled and the machine was running fine yesterday. Today the machine produced the error upon startup and the oil levels are all fine. Any ideas?? Thanks a lot

    Andrew
    Reply With Quote Reply With Quote
  2. 07-09-2009, 03:56 PM #2
    yours_prabhat
    yours_prabhat is offline Banned
    Send a message via MSN to yours_prabhat Send a message via Yahoo to yours_prabhat
    Join Date
    Dec 2008
    Posts
    239

    Question Z servo error

    please give the correct drive specs , Whereas you can check the signals by logic which are responsible to make drive enables , If the problem persists can call or communicate me on +91-9430737981 or on [email protected]
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. 410 Alarm X axis ecess error
    By scuba in forum Fanuc
    Replies: 16
    Last Post: 02-19-2024, 07:39 PM
  2. 434 servo alarm: Z axis detect error
    By padobranac in forum Fanuc
    Replies: 36
    Last Post: 12-21-2021, 03:18 PM
  3. HAAS VF-2 (104 ALARM) Y SERVO ERROR TOO LARGE
    By joanpim in forum Haas Mills
    Replies: 3
    Last Post: 09-12-2011, 10:24 AM
  4. Help! alarm 414 X axis detect err
    By CVMW in forum Fanuc
    Replies: 8
    Last Post: 01-10-2009, 02:42 PM
  5. alarm 105 (z servo error toll large) on Haas VF-OE
    By hoi.le in forum Haas Mills
    Replies: 4
    Last Post: 08-12-2008, 11:01 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules