Hello everyone,
I recently started the conversion of a g0602 lathe and I have a couple of questions. Hoping you guys can help.
I'm working on the enclosure and trying to avoid the dreaded " noise" that I've been hearing about. I do have a separate enclosure for the vfd, braking unit and resistor, but is that necessary even if the vfd output cables are shielded?
From what I've read it seems as if any ac within the control enclosure can be bad, but what about the ac going to the psu's? Should they be in a third enclosure? Really, how far should you go to separate the ac and DC? Or do I have it all wrong? I may be in over my head.
What spawned this post was me shopping for cooling fans. Can I use 115vac fans in the same enclosure with Bob, drivers, and all of the other sensitive electronics, or should they be powered off of the same PSU as the drivers?
I'm really starting to think myself into a corner. Little help?
Thanks