[Twin-10s]

Hi,
I am working with a older supermax mill with a om controller.
i have been able to clear all the alarm codes so far but the last 3 i can not really find any info on.
417 x axis parameter....
427 y axis parameter....
437 z axis parameter....
anyone have a idea of what i need to do/check to be able to clear these?
thanks for any help anyone can offer.

[fanucman]

yea you need to put in the correct 8000 parameters for the servos...

[Twin-10s]

thanks for the reply!
any chance you know where i can get a list of what parameters i need to enter?
i do have the books for the machine/controller but can not find any real info on the parameters needed.
thanks again!

[fanucman]

thanks for the reply!
any chance you know where i can get a list of what parameters i need to enter?
i do have the books for the machine/controller but can not find any real info on the parameters needed.
thanks again!

honestly the best place to get them from is by calling the people who made the machine... they usually will have some sort of backup for parameters...