hi
i have a c11g rev 5.4 board , is it possible to control the direction of the spindle from mach and not only the on off function and speed. i have a commercial vfd with frw,rew and com terminals.
hi
i have a c11g rev 5.4 board , is it possible to control the direction of the spindle from mach and not only the on off function and speed. i have a commercial vfd with frw,rew and com terminals.
Take a look at the wiring diagram here :
http://www.machmotion.com/pdf/Mach3%20Setup%20Guide.pdf