Hello
The company where I work has a Economos IP3200 "Sealjet" Lathe with a Sinumerik 810T controller, this machine is now refusing to complete any programme and stops on any G01 command in either X or Z plane, on the PLC screen can see the set values and the actual values of zero. Replaced the G01 command with G00 (took the material out) and it ran through until the next G01 command, tried changing the set values of G01 and still stopped at the G01 command. The problem definatly seams to be with the carrying out of G01.
Anybody got any suggestions?
Many Thanks
Mike