Originally Posted by
jrogus
We have a VF4 (1996). Does anyone know if it has spindle orientation. Would like to put on a 90 Deg. head and was wondering if I could orientate it to a certain deg. other than the home orientation.
The 90 degree head has to be located by a pin in a block bolted to the end of the spindle housing. Spindle orientation has no effect on the position of the 90 degree head, but many of them can be adjusted to almost any angle relative to the X Y directions, only not under program control it has to be set and locked.
An open mind is a virtue...so long as all the common sense has not leaked out.