I have a PL3B gang slide flat bed lathe that has spindel bearing's that are noisey and I would like to rebuild the headstock I don't have a manual that has a breakdown illistration of the HS look's preaty simple I can remove it from the base or work on it where it sit's I'm working on the tin right know paint ect would be a good time too tear into it with the sheetmetal out of the way REM checked with the factory and they have a part's manual end a operator's manual about $600.00 for the pair I have the operator's man. and I asked If they could Email a pic of the spindle breakdown I was hoping that some one might have some insite on this subject Wiring print's would be helpfull espicaly for the Mfunction relay's Thank's Kevin