[jorgehrr]

Nakamura TW10 Fanuc 18

I'm stock, please help.

My machine can not run continuously anymore, it stops always in the block with G131. We replaced a broken collet from that side (right side), and every since we can not run the job. Our maintenance guy is out this week.

I do not get any alarms, it just stops when is feeding out in the block with
G131

Any ideas???????

Thank you in advance

George

[sakis]

have you tried to reset your pickoff point? It might think your part is to long or to short.

[jorgehrr]

Mmmmmm.

I can try that...but

The part gets picked off and the operations in the second spindle go without any problems.
The problem is when machine is feeding out for the next piece, it stops right when the "stock stop" is in position, machine feeds out and that's it, it will not move after that.

Thank you for you replay, I'll try the reset, but if any other idea pops please let me know.

Cheers

George

[sakis]

i have only used G131 when transfering from one spindle to another. Sorry for the bum steer.

[stjohn_goldfingle]

Old post but I am wondering how you fixed this? I also have nak tw10 and am trying to do sub spindle transfers with fusion 360....

cheers!