[PaulZad]

Hi Folks,
this is my first post. I have a new person running my Mazak and he used a set screw that was too long for the tool holder to hold his 1 inch mill. The protruding screw evidently made the tool sit in the Toll Changer Arm slanted and it got stuck. I got the tool out but the arm is now not moving. I get an alarm code 261 ATC ARM RETRACT SENSOR MALF. Can anyone help????

Thanks in advance!!!


Paul

[TiggerII]

What Control? What machine?

[MTSS Service]

Hi There;

Depending on machine type and control there are procedures that you can use to correct this problem.
However , you need to post what type of Machine Model you have and which control you have on it as well.

Larry (MTSS)

[PaulZad]

Sorry for not giving all the important info on the machine, I'm new at these kinds of forums.
Our Mazak is a V-414/22 and it has a Mazatrol Plus controller.

Man it would be great if there was some way to re-home/reset that ATC arm.

Thanks again in advance!!!!

Paul

[MTSS Service]

Paul;
Contact me via e-mail @ [email protected]. The procedure is way to long to be posted in here.
I'm certain I may be able to help you out on your problems.


Larry (MTSS)