[nastek]

Dear All,
I am facing problem on Kuraki horisontal Mill (Fanuc10), the first time i got alarm Ram Parity Error, and i have initialized.
please somebody help me, how to input parameters by RS232?
i have back up on punched tape but the machine doesn't have tape reader.
can i read tape data on other machine first and save to NC data?

Thanks for help

[yours_prabhat]

if you have hard copy of data than you can put manually or you can attach any other fanuc tape reader with your machine If you want to know more mail on [email protected]

[memoryman]

the option parameters have to be input in IPL mode. Do you have a these on paper?
Bill

[memoryman]

also, the PC parameters have to be input manually (cn not be done through the tape reader or serial port). Do you have those written down?
Bill

[MysticMonkey]

http://www.cnczone.com/forums/archiv...p/t-15844.html

according to this thread VPCNC might be able to help ?
http://www.cnczone.com/forums/member.php?u=47730

[stevo1]

Nastek,
If you initialized the control then you will have to reenter everything. First thing you have to do is power on into the IPL mode then enter your option parameters in hexadecimal format. You then have to enter your communication parameters so you can communicate via RS232. Now you can download your parameters. Now you have to hand input your counters, timers, keeprelay data. Last you can do your programs.

Here is a thread that explains the most of the details to do the above. Let me know if you have any questions.
http://www.cnczone.com/forums/showth...ht=hexadecimal

Good luck,
Stevo

[MysticMonkey]

He needs to get the parameters off the punch tape first !

Nastek,
If you initialized the control then you will have to reenter everything. First thing you have to do is power on into the IPL mode then enter your option parameters in hexadecimal format. You then have to enter your communication parameters so you can communicate via RS232. Now you can download your parameters. Now you have to hand input your counters, timers, keeprelay data. Last you can do your programs.

Here is a thread that explains the most of the details to do the above. Let me know if you have any questions.
http://www.cnczone.com/forums/showth...ht=hexadecimal

Good luck,
Stevo

[nastek]

Thanks guys, for help me, i have input parameters, and machine working well.

Regards

Nastek

[fanucman]

next time you need to do a reset and delete,

then input your 900 parameters at once ( dont turn off machine till they are all in)
then set up your rs232 parameters and load the machine