I am asking several questions since I do not have experience with Fanuc.
I have a machine center, where I am able to jog and to zero the machine. I was unable to do anything else.
My next "jump" is to try that the machine would move following some gcode in MDI mode (appers to be the most basic). I have read the manual, but I must be missing something. What did I did:
1) Power, and zero all axis
2) I went to MDI mode, and typed G00 X100
3) Pressed INPUT
4) This line was entered to the text box (as in the picture)
5) Pressed START, but nothing happens (using the interlock switch, since I did not mounted the door of the machine). I have notice that the led behind the start stays on for one brief instant, then goes off. Machine does not move.
I have read another program in machine memory, and I notice that all the lines end with ";" I do not know how to input this or to go to a new line in MDI mode. I know, those are basic questions, but I need to ask them.
I have attached a picture, that is the state before and after I press START. No alarm is displayed or anything else.
Any ideia or sugestion is very welcome.
Thank you