505,911 active members
3,575 visitors online
Register for free
Login
Results 1 to 2 of 2
  1. #1
    Registered
    Join Date
    May 2003
    Posts
    267

    Finding center of hole

    In mach3 mill using a probe sensor, how do you find the center of a hole?

  2. #2
    Registered
    Join Date
    Mar 2004
    Posts
    1493
    The procedure is the same wheather you are using a sensor or edgefinder or whatever.

    move to approximate middle of hole.
    Z down to inside the hole.
    Move X+ till touch,record
    Move X- till touch, record, average of two reading is X center

    Do same for Y

    Karl

Similar Threads

  1. boring a hole thats off center
    By nmcdairmant in forum General Metalwork Discussion
    Replies: 7
    Last Post: 11-02-2008, 07:22 AM
  2. 3/8 shaft with center hole?
    By DennisCNC in forum Community Club House
    Replies: 4
    Last Post: 09-14-2007, 01:36 AM
  3. pierce for center of hole
    By bearracecars in forum General Waterjet
    Replies: 2
    Last Post: 09-01-2007, 04:46 AM
  4. finding center of a hole
    By BeerFizz in forum Mach Mill
    Replies: 1
    Last Post: 06-15-2007, 01:17 AM
  5. Finding the center
    By Tazzer in forum General Metalwork Discussion
    Replies: 6
    Last Post: 08-05-2006, 06:18 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •