hye guys, anyone can help me with this problem..In 3d programming i am using surface finish shallow in my cavity side..but the problem is lead in and out of toolpath is not too good because it automatically created by the system..can i anyone tell me how to control the lead in 3d program..because it will cause tool mark on that side..thank you
Results 1 to 3 of 3
-
10-12-2009, 06:08 PM #1
Registered
- Join Date
- Jan 2009
- Posts
- 7
How to control lead in and out in 3d programming
-
10-13-2009, 11:43 AM #2
Flies Fast
- Join Date
- Dec 2008
- Posts
- 3109
If the surface is not ending against a wall, you can extend the surface by 2-3mm
Also in "Gaps" the tangent arcs entry/exit is an option, ( not available if you use "Follow Surface" )
Another is "Direction", this is a added linear lead in/out, do not use with "Zigzag", it is best to set this after getting the surface parameters correct ( check the endpoints of your surface paths carefully if using "Direction"
-
10-14-2009, 04:49 PM #3
Registered
- Join Date
- Jan 2009
- Posts
- 7
thanks..i will try that then i will feedback to you for any improvement..
Reply With QuoteSimilar Threads
-
Conversational programming on CNC 88HS control
By rifleman in forum FadalReplies: 4Last Post: 01-23-2009, 08:01 PM -
Fanuc programming/control.
By Twenty20 in forum FanucReplies: 2Last Post: 09-10-2008, 12:45 PM -
18i-t control programming ?
By crash80 in forum FanucReplies: 0Last Post: 05-25-2008, 03:28 PM -
15i control help for (AiCC) (hpcc) high precision contour control programming
By gibbsmaster in forum FanucReplies: 2Last Post: 12-28-2007, 04:57 PM -
Using control comp in lead in-outs
By badRandle in forum MastercamReplies: 22Last Post: 08-07-2007, 08:22 PM
Posting Permissions
