I have problem replacing the bottom piece on SCHMALZ vacuum block. Anyone out there has same experience? It take me one hour or more ... Hand is so tired. Any better way ....?
See the picture attached...
Results 1 to 1 of 1
-
10-19-2009, 12:29 AM #1
Registered
- Join Date
- Sep 2009
- Posts
- 2
How to change the pod on SCHMALZ vacuum block
Reply With QuoteSimilar Threads
-
How to change Tool change position(About MAZATROL T1 control)
By liushuixingyun in forum Mazak, Mitsubishi, MazatrolReplies: 6Last Post: 01-07-2014, 01:33 AM -
Vacuum table and vacuum pump
By garagefela in forum DIY CNC Router Table MachinesReplies: 19Last Post: 01-25-2012, 05:30 PM -
New kid on the block
By micfixer in forum Community Club HouseReplies: 3Last Post: 04-01-2008, 03:40 PM -
1 2 3 block
By sundy58 in forum Uncategorised MetalWorking MachinesReplies: 1Last Post: 02-20-2008, 11:46 PM -
RS232 program block by block
By smoregrava in forum CNC (Mill / Lathe) Control Software (NC)Replies: 3Last Post: 12-22-2005, 07:52 AM
Posting Permissions
