Dear expert machinists:
Here is the problem: I have a lot of aluminum extrusions, but they are all a little thin: 1/8".
Now, when I need a thicker piece, I was wondering if I could bond together a few thinner
pieces, with some type of adhesive, and end up with a material "almost as rigid" as
the real thing: say, three 2"x1/8" bars to make a 2"x3/8" bar.
Is this doable? What kind of adhesive would strongly bond aluminun to aluminum?
Epoxi? How to prepare the surfaces and conduct the cure?
Thanks a lot for your suggestions
Nelson