[dre]

do anyone have a picture of the parameters for a mazak qt 25 with t2 controller

[mike.t]

i have all of them but the last page. i need last page bad

[In2processAU]

Hi All,
I'm in great need of the parameters for a QT25 T2. Mainly the "K" section parameters but all of them would be great.
Thanks, Scott

[mike.t]

were would you like them sent to

[In2processAU]

Hi Mike, not sure what u mean mate? I was told that I need the "machine paramters" as I lost all of them when swapping out a board. The mazak technician came out and punched in all of them from my manual except for the "K section" so he said. problem is he left mazak so now there is nobody here in Western Australia to service Mazaks!
If there is somebody on this forum that knows evrythinf about mazaks and wants to move here I recon there would be more work than you can handle!
Thanks, Scotty

[In2processAU]

Hey Mike,
Sorry dude its late here. Now I understand what you are asking. Here is my email: [email protected]
Thanks heaps mate!

[In2processAU]

hey Mike, where did ya go??? Pls don't run away without sending me the parameters!! Pls Pls!
My machine has been down for 8 weeks now!!

[mike.t]

What email address should i send it to.

[In2processAU]

Hi Mike,
Did you send the email yet, as I didn't get one from you. Thanks for your help with this as my macine has been nothing but problems since I bought it.
Cheers, Scotty

[In2processAU]

Hey Mike,
Did you get a chance to send those parameters yet?
[email protected]
Scotty