585,927 active members*
3,765 visitors online*
Register for free
Login
IndustryArena Forum > CAM Software > Mastercam > Create Arc And Lines From A N-Spline

Thread: Create Arc And Lines From A N-Spline

Results 1 to 2 of 2
  1. 11-02-2009, 12:26 AM #1
    thebowman
    thebowman is offline Banned
    Join Date
    Aug 2009
    Posts
    106

    Create Arc And Lines From A N-Spline

    Is there a way to do this in X4. Apparently their was Mastercam X as it's mentioned in the book I'm reading. Can't seem to find a way to do it. I tried the "Simplify" tool and that didn't work no matter where I set the tolerance. Also looked at the C-hooks and couldn't find anything there either.
    Reply With Quote Reply With Quote
  2. 11-02-2009, 12:39 AM #2
    jcnewbie
    jcnewbie is offline Registered
    Join Date
    Oct 2009
    Posts
    77
    Try Edit - Trim Break - Break many pieces
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Take a look spline job
    By turboless in forum Employment Opportunity
    Replies: 0
    Last Post: 05-22-2009, 04:04 AM
  2. spline help,mc9.1
    By GRANDPA in forum Mastercam
    Replies: 10
    Last Post: 03-10-2007, 01:00 PM
  3. lines-arcs vs spline problem
    By metlcutr55 in forum Uncategorised CAM Discussion
    Replies: 1
    Last Post: 07-07-2006, 04:16 PM
  4. How do I create solids from lines?
    By HawainPand in forum BobCad-Cam
    Replies: 2
    Last Post: 09-12-2004, 06:36 AM
  5. Spline
    By scottsss in forum Autodesk
    Replies: 13
    Last Post: 07-15-2003, 04:30 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules