502,750 active members
5,151 visitors online
Register for free
Login
IndustryArena Forum > MetalWorking Machines > Colchester Tornado lathes > Tornado 300, Alarm AL1018 Turret to slow
Results 1 to 2 of 2
  1. #1
    Registered
    Join Date
    Feb 2009
    Posts
    22

    Tornado 300, Alarm AL1018 Turret to slow

    Hi, I had a small accident with tool change, and the Turret tried to change tool inside a workpiece. That didn't work of cource...

    My problem now is that the Tornado 300 shows alarm message AL1018, and will not reset the alarm. The turret is also not locked, i can turn it around.

    Anyone that have done the same fault i did and fixed it ? I have looked all over the manual, but can not find information to fix my problem.

    Controller is Fanuc OTC-F and the turret is Duplomatic

  2. #2
    Registered
    Join Date
    Feb 2009
    Posts
    22
    I have now fixed it.

    What I had to do was to open the Duplomatic logo cover and remove the Turretmotor cover. Then I pushed down the locking pin and turn the motor 3 revs to the right.
    The turret locking pin popped up again, but the position of the turret was correct. When I turned on the lathe again the error was gone..

    Happy Lets start production again

Similar Threads

  1. Replies: 11
    Last Post: 11-01-2012, 10:10 AM
  2. servo turret alarm
    By Hifeed in forum Fanuc
    Replies: 3
    Last Post: 07-15-2012, 07:37 AM
  3. Replies: 10
    Last Post: 05-21-2012, 06:29 PM
  4. Replies: 1
    Last Post: 10-05-2009, 04:32 PM
  5. doosan 2020 turret alarm
    By sebturbo2000 in forum Daewoo/Doosan
    Replies: 3
    Last Post: 08-28-2009, 09:03 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •