I would like to get some t-slot covers for my mini mill - any recommendations? I mostly have a Kurt vice mounted so I'm looking for the individual snap in type.
I would like to get some t-slot covers for my mini mill - any recommendations? I mostly have a Kurt vice mounted so I'm looking for the individual snap in type.
once I made mine on my own , wasn`t so difficult.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
plywood! Cover the entire surface cut to fit the vise.
A/C exterior!
www.use-enco.com
They sell the ones for Bridgeports so I assume they might have some for your Mini Mill.
Toby D.
"Imagination and Memory are but one thing, but for divers considerations have divers names"
Schwarzwald
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
www.refractotech.com
We used 5/8 x 1 cold drawn flat stock on our VF5.
It fits the slot width perfectly and comes up just to the bottom of the chamfer on the slot, leaving no crevices for chips.