I need it to stop
can I turn off the spindle orient before each hole in order to save cycle time?
the machines are OSP-100m and -700m
the tapping code is G284
this is all new to me so thanks for any help at all
Kenny
I need it to stop
can I turn off the spindle orient before each hole in order to save cycle time?
the machines are OSP-100m and -700m
the tapping code is G284
this is all new to me so thanks for any help at all
Kenny
G284 is rigid tapping, right?
Try a floating tap holder and G84.
The M3 is not required to actually start the spindle
it can safely be deleted
The G84 and G284 forces the spindle CW when the tool goes to the R-plane when starting the cycle and stops the spindle at when it returns to the R-plane before going to the next hole.
Prove off the cycle away from the part, for your own peace of mind