i have a miyano fanuc 10t controller im trying to tap 1/2 -14 npt using a g32 tapping cycle when it starts tapping the chuck just about comes to a stop.turning 400 rpms .071 per rev depth 1.06 can someone help me with why the chuck wont stay at 400 all the way through. thanks.
Results 1 to 3 of 3
-
12-28-2009, 03:42 PM #1
Registered
- Join Date
- Dec 2007
- Posts
- 48
Miyano fanuc 10t threading problem
-
12-28-2009, 08:33 PM #2
Registered
- Join Date
- Feb 2006
- Posts
- 992
Post your program here so we can help you. I suspect you have G96 instead G97
The best way to learn is trial error.
-
12-30-2009, 12:47 AM #3
Registered
- Join Date
- Nov 2006
- Posts
- 418
Also, what HP does your machine have behind the spindle? I haven't run the numbers but I would say you will need atleast a 10HP spindle motor.
Some smaller lathes don't have enough juice to do that size of NPT tap - especially after many years of use and increasing frictional power losses.
Reply With QuoteSimilar Threads
-
Miyano BNC-34C turret problem!!!
By rai in forum FanucReplies: 5Last Post: 05-03-2016, 03:01 PM -
STAMA MC320 threading problem (Fanuc OM)
By diz in forum FanucReplies: 1Last Post: 04-15-2009, 05:55 AM -
Threading problem on Miyano
By Mark18969 in forum MetalWork DiscussionReplies: 0Last Post: 11-10-2008, 02:28 PM -
Miyano T5V-25 problem.
By tac8357 in forum DNC Problems and SolutionsReplies: 1Last Post: 02-02-2008, 03:42 AM -
Miyano parameter Problem
By AFX in forum FanucReplies: 12Last Post: 02-01-2007, 08:28 AM
Posting Permissions
