Originally Posted by
concoo
it easy to do .
open the post -> goto here
# --------------------------------------------------------------------------
# General Output Settings
# --------------------------------------------------------------------------
force_wcs : yes$ #Force WCS output at every toolchange?
progname$ : 1 #Use uppercase for program name
css_start_rpm : yes$ #Do direct RPM spindle start prior to CSS?
css_end_rpm : yes$ #Do direct RPM spindle prior to Retract?
prog_stop : 1 #Program stop at toolchange: 0=None, 1=M01, 2 = M00
tool_info : 3 #Output tool information?
#0 = Off - Do not output any tool comments or tool table
#1 = Tool comments only
#2 = Tool table only
#3 = Tool comments and tool table
use_pitch : 0 #0 = Use feed for tapping (force Feed/Min), 1 = Use pitch for tapping (force Feed/Rev)
rigid_tap : 1 #0 = Floating tap output
#1 = Rigid tap output (Set parameter 5200 bit 0 to 1 for rigid)
#(Set M code for rigid tap in parameter 5210)
tap_feed : 1 #0 = 2/1 (in/mm) decimal places, 1 = 4/3 (in/mm) decimal places
thread_address :1 #Thread pitch address for lathe threading, 0 = Use F, 1 = Use E
change number 1 to 0 at red color, you will got F instead of E .
hope it will help .