Has anyone used this setup....
http://cnc4pc.com/Tech_Docs/Product_...3_C22_MPG2.pdf
I'm thinking of buying it would like to here of anyone has done it and if they have had any problems ??
Cheers
Clive
Has anyone used this setup....
http://cnc4pc.com/Tech_Docs/Product_...3_C22_MPG2.pdf
I'm thinking of buying it would like to here of anyone has done it and if they have had any problems ??
Cheers
Clive
You might also want to look at the new PMDX-125. Smoothstepper mounts on the board, and it can accept 24V inputs.
http://www.pmdx.com/PMDX-125
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
wow i like the looks of the PMDX-125. bookmarked
Hi thanks for that, seems the only thing it doesn't have is spindle control.. Have you used this system ??
I must admit the last Breakout board I used C11T did have issues with the Spindle Speed 0-10v but I never sent it back as it was over 12months old by the time I got around to using it.... So might have been just a dodgy connection...
Just trying to see if there's any other options out there for my Shiz AN-S..
Cheers