How's it going? First post on CNCZone.com!

I have recently acquired a Taiwan Takisawa EX-110 Lathe with a Fanuc 21i-t controller. I haven't been able to figure out the tailstock programming. I know that an M10 extends the quill and M11 retracts it but I get an alarm code when I attempt to use this programming. The quill extends and then it acts like it times out, I get an Alarm 1022 M, S, T, B SGNL. ARE NOT COMPLETE message.
Has anyone else encounter this message? Does anyone have a remedy for this?

Thanks,
Crash