does anybody know how to make the post put the operation numbers that are assigned to the toolpaths in mastercam, as comments in the nc program
before each toolpath

ive been spending a lot of wasted time triying to figure out which toolpath my setup guys are wanting me look at if something is not right

btw i already called my reseller and im not going to pay thousands of dollars for a custom post, when something that should have already been there to begin with.
I also am aware I can type a comment in at each toopath but why do that when it already has a number assigned, besides when you use a transform toolpath to copy opertions it's not pheasable to write a comment in for 100 diffrent toolpaths

thankyou in advance to anyone who can help!!!