Hi all,

I'm a little new to all this, I was hoping someone could help wit an easy answer.

I would like to fit (obviously only if possible...and it should be) some NPN proximity sensors to the Gecko 540. These shall serve as homing sensors. They do require 10-30 VDC and are 3 wire.

Obviously I dont want to let the smoke out of either the Gecko 540 or the sensors.

Is there an easy way to fit these proximity sensors to the Gecko 540?? Pull up resistors?? Anyone have a drawing they could share?

I'd be very much indebted for any help.

Thanks

Tom