Hello All.
I have finished my fixed gantry machine and with a 12" x 12" table. However, some of the parts that I wish to cut are longer than this. I have a good idea as to how I go about referencing a long part on a small table, but wish to hear from those of you that already do this type of cutting. How do you do it? I'm talking about settting up the CAM software and the tool paths.
I was given a good example here
http://www.rcgroups.com/forums/showp...08&postcount=2
and a pointer about the softwre set up here
http://www.vectric.com/forum/viewtopic.php?f=12&t=5801
Regards,
Martin.