Tool list in header
Good morning all I have a simple question about changing a post to add a tool list to the header of my programs,
The rep was by last week and helped the mill guy's with a problem and did this for the mill post. So of course I needed it for the Lathes x14
Found the part in gen setting to change this but changing it made things worse
of course I did not change the oring.post so back to it I went.
Is there a easy # change or do I need to get the book.
Thanks
IF ITS NOT BROKE YOUR NOT TRYING HARD ENOUGH
Ashes to ashes , dust to dust , If it wasnt for Harleys the fast lane would rust.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)