[johnrei]

I'm looking for someone in the Milwaukee WI area that can help me set up the software on a taig cnc mill. I have two, one that I've been using for a couple of years, with steppers, just as it came from Taig. I have a second Taig mill with servos, and a different controller from Cand cnc, all assembled, but I'm not confident in doing the initial setup. I'm a sculptor and do not use these daily, so it's not become second nature to me.

Thanks,

John
[email protected]

[awerby]

But I'll try to help. Are you sure those are servos on your mill? Taig also makes a model (the DSLS 3000) with steppers equipped with encoders - could that be what you've got? The only Taigs commercially available that come equipped with servos are from Supertech: Super Tech & Associates Main Web Home Page Is that what you've got, or was this somebody's home-brew setup? C&CNC are also still around - you should ask them if you're having problems with one of their controllers: http://www.candcnc.com/ Does your controller have the Gecko stepper drives, or G320 servo drives? Are you trying to use Mach3, or some other control program?

Andrew Werby
ComputerSculpture.com — Home Page for Discount Hardware & Software

I'm looking for someone in the Milwaukee WI area that can help me set up the software on a taig cnc mill. I have two, one that I've been using for a couple of years, with steppers, just as it came from Taig. I have a second Taig mill with servos, and a different controller from Cand cnc, all assembled, but I'm not confident in doing the initial setup. I'm a sculptor and do not use these daily, so it's not become second nature to me.

Thanks,

John
[email protected]

[johnrei]

It has the CandCNC ps-650 controller with geckos.

[johnrei]

mach3