[Flyinfarmer]

Hello All

I have a Thermal Dynamics Cutmaster A80. Using it with a TM1 and the Torchmate AVHC

I am trying to find a manufacturer / part number for the female pins inside the cnc rear panel connector.

Only 4 out of the available 14 pin locations are being used.

Tried Thermal Dynamics; couldn't get anywhere with their customer service.


Thanks
Dave

[Mike 1948]

Hello All

I have a Thermal Dynamics Cutmaster A80. Using it with a TM1 and the Torchmate AVHC

I am trying to find a manufacturer / part number for the female pins inside the cnc rear panel connector.

Only 4 out of the available 14 pin locations are being used.

Tried Thermal Dynamics; couldn't get anywhere with their customer service.


Thanks
Dave

Try Jameco electronics they have everything. Here is what I used on my Cutmaster 52. http://www.jameco.com/webapp/wcs/sto...oductId=495031
http://www.jameco.com/Jameco/catalogs/c284/P53.pdf


Good Luck
Mike

[Flyinfarmer]

Cool!

Thanks Mike, that is just what I was looking for.

Regards
Dave