Hurco VMX or Haas VSS?
--------------------------------------------------------------------------------
Hello everyone. Was wandering if anyone out there has experiance or owns a Hurco VMX and Haas VSS? I'm in the market for a new machine and am considering these 2. I mainly program on the cnc interface with g codes. More complex parts I use mastercam.
I mainly do one offs and small lots of 10 -50 parts in ferrous and non ferrous material. Job tollerance vary from .0004-.005".
1.What are the pross and cons of each machine?
2 Which machine hold better tolerance? Can they hold .0005" consistantly over the course of a shift.
3. Which machine is more rigid? Which gives better surface finnishes?
Any other comments or info is greatly appreciated.
Thanks