Hey community,

I have been trying to get a .pst/.post file for a Tormach 1100 for Mastercam. So far I have come up with nothing but endless rabbit holes, I was hoping someone had a .pst file for Mastercam or any other CAM software to even just try at this point. I have contacted Tormach and they no longer have that post processor available and they only sent me sample code to do it myself. Now I am not opposed to doing myself but there is a lot of code and would even take guidance through it. I don't need to change a lot, safety line and tool line/tool offset are the only two I need to change and then some rearranging of order of lines.

Thank you all for your time,

Conner