[dlaery]

somehow the orientation has changed.
as shown in the pic in the top workspace Z points to the right.
Normally when I do this the plane I see is Y is up and X is pointing to the Right.
I haven't changed anything that I know of.
I can't seem to figure out how to change it back.
When I tried to use Translate a line in Y it wouldn't move and I realized the USC was off.
any idea what I have done to cause this and how to get it back. Will this make my G-code wrong

[BurrMan]

somehow the orientation has changed.
as shown in the pic in the top workspace Z points to the right.
Normally when I do this the plane I see is Y is up and X is pointing to the Right.
I haven't changed anything that I know of.
I can't seem to figure out how to change it back.
When I tried to use Translate a line in Y it wouldn't move and I realized the USC was off.
any idea what I have done to cause this and how to get it back. Will this make my G-code wrong

It's in "lathe mode"....

Preferences- (units i think)

[dlaery]

Wow,:banana:
thanks. that's where is was.