527,827 active members*
2,259 visitors online*
Register for free
Login
IndustryArena Forum > CNC Electronics > Servo Motors / Drives > Yaskawa SGDB-02VN with Mach3
Results 1 to 2 of 2
  1. #1

    Yaskawa SGDB-02VN with Mach3

    Hello

    I am trying to get an old Biesse rover 23 running with mach3 and Smoothstepper Ethernet 51 I/O Motion controller. Looking in the manual, I have found a "connection and wiring" for Mitsubishi and I thought I could use this but with smoothstepper instead using pin an dir..

    I am stuck with the pinout from the SGDB-CANV, I can not find any manual, after days of looking, wich pins are what in the 13 pins jacket labaled 1CN.

    Any ideas?
    Attached Thumbnails Attached Thumbnails ScreenHunter_1005 Sep. 03 23.07.jpg   ScreenHunter_1004 Sep. 03 23.06.jpg  

  2. #2

    Re: Yaskawa SGDB-02VN with Mach3

    SGDB-xxxN are early Mechatrolink-I drives. the bus gets connected to the blue 8-pin honda connector at the top left. 1CN circled in red is for limit switches and the like.
    the manual is available on the web, google for SIE-S800-26.4B. i doubt about mach3/SS...

Similar Threads

  1. yaskawa SGDB-10VD Drive
    By tracar in forum Servo Motors / Drives
    Replies: 0
    Last Post: 11-03-2019, 05:07 AM
  2. YASKAWA SERVOPACK SGDB-10VD
    By bujar.gashi in forum Servo Motors / Drives
    Replies: 3
    Last Post: 07-02-2018, 02:51 PM
  3. Swap yaskawa sgdb-15adg for a sgdb-10adg
    By gzero in forum Servo Motors / Drives
    Replies: 2
    Last Post: 08-24-2016, 04:55 AM
  4. Need replacement for yaskawa sgdb-10adg
    By gzero in forum Servo Motors / Drives
    Replies: 2
    Last Post: 02-23-2015, 01:54 PM
  5. Cable for programming Yaskawa SGDB Parameters
    By grc in forum Servo Motors / Drives
    Replies: 2
    Last Post: 08-30-2010, 03:00 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •