I am looking to purchase a Dyna DM3000 lathe or maybe even a Southbend Magnaturn 612 if you have something available please do let me know.
Your help is greatly appreciated,
Bruce
Type: Posts; User: bmklawt
I am looking to purchase a Dyna DM3000 lathe or maybe even a Southbend Magnaturn 612 if you have something available please do let me know.
Your help is greatly appreciated,
Bruce
Looking to buy a desktop CNC lathe, I like the looks of South Bend Magnaturn 612 although I have never seen one in person, I did do some work on a Emco PC Turn 50 and that seemed to be an okay...
Added a wire from the controller 5V terminal to the gecko drive and it runs perfectly now
With the help of [email protected], I came up with this diagram for hooking up my controller. The stepper motor will move when I use the test button on the Gecko drive but will not move when I...
Hello,
I need some hand-holding as I try to put together a "World of Word" indexing controller, I'm not bright enough to figure this stuff out for myself.
I have purchased the controller from...
99% of the material we cut it 1/4", 1/2", 3/4" plywood and 2" foam.
Time is really not an issue, we always have a few months to get thing cut, right now we are able to use a local companies router...
Hello All,
I am looking for any recommendations for a 4' X 8' CNC router for our High School theater department, the budget is $10,000.00 to be up and running. We are looking for 4' X 8' router...
I replaced the 4 GTK45583 transistors with 2N3773 and the amp is now working.
I bought the transistor from www.digikey.com/scripts/dksearch/dksus.dll?vendor=0&keywords=2n3773+ about $4.00 each
Bump
They want $90.00 each for the Glentek transistor so yes I am looking for a non Glentek replacement.
Looking at the 3 amps I have, each has 4 GTK45583 transistor, I just noticed one transistor of the...
I have a Gentek servo amp made for Anilam in the early 1980's model GA4561, there are four transistors on this and I know at least one of them is bad. Transistor is a GTK45583, replacement...
If anyone could help me out with the pin-out of an early 1980's Glentek GA4561 servo amp I would be grateful.
Your help is much appreciated,
Bruce
Need step/dir to analog to converter, I've never used a pixie but have heard good things about them.
I Have 1988 Anilam Crusader II, has manual control also with 140vdc servos, glentec or westamp...
I bought these because they said thery were ABEC 5
It also says on the bearing 0770 and explorer, I found this on the SKF website.
SKF Explorer angular contact ball bearings are manufactured...
How do I tell if this is a ground or rolled ball screw, My first thought was it is a ground ball screw but then I noticed the groove on the land which I have seen on a lot of rolled ball screws.
All...
I bought new bearings for the ball screws on my mill, SKF 7204 BECBP.
http://www.skf.com/skf/productcatalogue/Forwarder?action=PPP〈=en&imperial=false&windowName=null&perfid=123002&prodid=1230020204...