Search:

Hi Alex...

We do a lot of DNC & MDC (machine monitoring) for CNC controls, and so I would suggest you use the Fanuc FOCAS protocol. It is standard in your Fanuc 31i control. It runs over port 8193...

Hurco's zip code backwards - 86264

I think that you are trying to use the wrong channel (port). There are 2 serial ports on the Fanuc 160i-L control. The first is the PCR-20 Honda connect called JD36A that shows up as Channel 0 or 1. ...

Yes - there is a Yasnac J300 memory upgrade available to 2 megs (5120M) from Nexas Networks. The kit comes with a special PCMCIA flash card, JMM01-02 board and instructions. All one needs is a laptop...

It sounds like you know where these special "D" codes are as you mentioned it in your post. The default Mori passcode is only 76543210 so the key is to re-enter them if you have a list of them...

The picture of the Fanuc 0-MC firmware version is missing the left digit. I suspect that you have 0462-19 only works on a Fanuc 0-MC mill by the way. I have a special DNC firmware upgrade for 0469-05...

I now this post was a long time ago, but the short answer for others who look at this is that "yes" the normal Fanuc cable is a null modem with 6, 8 & 20 jumpered at the DB25 male cable end. The LSK...

I now this is a old thread, but ...

ironically I have just finished making a memory upgrade and DNC manual for a client with the same Fanuc 0-MAD control using 412-08 Firmware on the...

I believe that the wire EDMs that you have are based upon standard Fanuc controllers - the Fanuc 18iA and 32i by the sounds of it. The Ethernet link for Fanuc's supports a variety of protocols...

To determine which Fanuc 0 you have, I would suggest checking the masterboard number:

Fanuc 0-A Masterboards (max memory is 120 meters of 48k):
A16B-1010-0150
A16B-1010-0210
A16B-1010-0240
...

You can probably watch e-Bay and get a Fanuc 6 Maintenance manual as they do come up BTW.

With regards to the 904 - Dan Fritz is right - backup what you can, but I bet you are past that stage as a...

Fanuc 11s have parameters that set which port, and which protocol you will use for input and output in both foreground and background modes.

Note that CD4 on the masterboard is I/O RS232C...

Check out NetDNC from Memex Automation (www.memex.ca). At $275 for a single seat license, you can configure as many machines as you want (like a virtual switch-box) but only transfer with one port at...