If youre interested, Im trying to finish up a brand new controller designed from the ground up to be flexible enough to operate almost any machine. It runs on an stm32 chip tho not an arduino. It...
Where today meets tomorrow.
Type: Posts; User: shooter64738
If youre interested, Im trying to finish up a brand new controller designed from the ground up to be flexible enough to operate almost any machine. It runs on an stm32 chip tho not an arduino. It...
If wrote a c++ libtary that does cutter radius compensation, which might be usable for your purposes. Mine runs inside a cnc control but I wrote it to work mostly independently.
I also am very confused, because I have been made to believe that a milling machine should have a spindle capable of 10-12krpm. Where as a router typically has a max spindle speed of about 20krpm. My...
Hey everyone!
I have been building a vertical mill. Its primarily constructed of 0.375" (9.5mm) steel plate. The steel sections are hollow, consisting of a plate with short sides, and bracing across...
I may be a little late to this convo. If you are looking for a 6 axis version of grbl, Heres is a version I have on github.
https://github.com/shooter64738/grbl-6-axis-synch
I don't know the specifics on how that servo needs to be driven but I would imagine it is similar to other servos requiring a driver, tach, direction, and so forth. I have some parker allen servo...
I used 5mm pitch ball screws in my setup. I have some closed loop steppers, and they are no different in performance than their open loop counterparts. The closed loop stepper and driver I used can...
I run an identical driver and similar motor configuration, however I used NEMA 24 motors. I have used the DM542T drivers, but I went with a power supply per axis. They are 60 volt 6 amp supplies...
Right.
Also correct.
You can certainly get accuracy out of it. And the version of the code I have below makes it reactive like a servo. If you move the stepper it will move back IF your...
Yes I completely agree it would be much easier. However a scenario like this is what I wanted to be able to handle:
You are cutting a circle/angle/ (any movement that requires the coordination of...
I know this thread is a bit dated, but I'll explain how I have encoded a stepper motor. I have a DM542T driver running a dual shaft NEMA 24 stepper at about 1200 RPMs. The way I set mine up was to...
Hello all. I work in a shop with some Fadal VMC's and Moreseki lathes. Im learning more about programming, and have been working out the parts to build a small machine at home. Hoping to learn some...