I"m working with a Milltronics Centurion 6 control. I'm new to Milltronics as I have ran Fanuc and HAAS controls. Is there any way to string lines off programs in MDI as the control has no end of block symbol? I tried plugging a keyboard into the control and use the end of block symbol and it doesn't recognize it and gives an error. Is it only possible to give one line commands in MDI at the control? Do I need to use a pc to load manually typed programs? Again I"m new to a older milltronics control and any help would be appreciated. Also if only 1 line strings in MDI can I just create a junk program to call up and edit it as a "clip board" or mdi program and use that for simple mill programs?