The title says it all.
We had a forum here for a week or so and now it's gone - why is that?
Martin.
Digital. Experienced. Powerful. - 100% Tool Management
The title says it all.
We had a forum here for a week or so and now it's gone - why is that?
Martin.
Beats me, I was enjoying it since I have been using Viacad for years.
Warning: DIY CNC may cause extreme hair loss due to you pulling your hair out.
I really enjoyed it because there seemed to be a better free flow than on the VC forums. That and faster responses from those people involved. You can't access the VC forums until you have already purchased VC, so that alone is a good arguement for a forum that is not controlled and moderated by the manufacturer.
Bob La Londe
http://www.YumaBassMan.com
Here is the original thread where I asked for it. Maybe if a few people ask WHY!?
http://www.cnczone.com/forums/sugges...m_request.html
Bob La Londe
http://www.YumaBassMan.com
Yeah, come on Admin - the forum attracted users right from the start!
Why kill it off before it got going?
Martin.
I think it would get more attention in the request forum.
Bob La Londe
http://www.YumaBassMan.com
my bad all fixed.
Thank you very much, Paul.
Martin.