[085eamon]

Currently i have a hurco hawk that has a cmos check sum error.
Reaching out for any help i cam get to get this rest.
On the main screen its asking for F1 to be pressed which on the monitor doesn't do anything.
I have a Ps2 keyboard but no adaptor yet for the db9 serial port on the electrical cabinet
The computer boots with 2 beeps and the screen loads up to the stage of the cmos checl sum error press F1.
The machine did run fine maybe 3 years ago but has been off power since then

[085eamon]

Ok so i got a keyboard hooked up managed to press f1 and got into the Cmos settings i followed a hurco service bulletin and went through all the standard and advanced settings.
I copied what bloke suggested in another post for the cylinder heads 1223 sect 50 etc amd manged to boot the system.
It brings me to the part set up screen and the progam screen
But the main controller none of the buttons work i can only use the keyboard.
It wont allow me to press manual power, cycle start to enable the drivers.
Its like the machine has forgot ot has the controller all the parameters needed to set it up arent there.
Really need help here if anyone even reads these anymore.