Hi there
Has anyone got the G41/ G42 compensation working in the XZ plane? And has the tool table been sorted out for the required parameters?
It is absolutely no use as a lathe control without...
Type: Posts; User: Gearman48
Hi there
Has anyone got the G41/ G42 compensation working in the XZ plane? And has the tool table been sorted out for the required parameters?
It is absolutely no use as a lathe control without...
I understand that the acceleration / deceleration ramp rates have to be observed but at 25mm/s^2 in one second the traverse speed can go from zero to 1500mm/min and in 1/2 a second it can change from...
Thanks thats solved the counter issue, what about the over run on slow speed?
So I have overcome the lethargy of covid and found enough bits in the scrap box to make the dedicated pendant for my little lathe.
See the photo, z+ z- X+ X- a threeposition switch which gives...
I was concerned that because I could see 5 expressions (~Loop to #OnInit) at the bottom of the shortcuts menu and they must be in a file somewhere, and didn't want to cause a problem, I have now...
Looks good but I cannot find "Expr.txt" in any of the folders
Scorpion, (with an r this time!)
Many thanks thats a useful document and useful advice, it will be a few days before I get to playing with hardware, so I will let you know the results when I make...
Scopion,
Thanks for the help, as soon as I can get back to the hardware I will rig a switch for the Alt inputs, and then start playing with user comands.
I expect there is some discussion on user...
Hi
When you right click on the jog panel you can select from 3 step sizes 0.01mm, 0.1mm and 1mm which is fine when working from the keyboard.
When using a simple 2 axes push button pendant for my...
Thanks folks lots of useful information,
I thought I might have done something stupid in my setup but the protection of files is intentional.
Hi
This would be the really useful solution to one of my problems and I thought it would be easy!
I imagine it is me being stupid but if I try to save Parameters.txt I get a message saying I...
Whilst not strictly on the same subject-
The standard Planet code colour scheme makes code really easy to read, has anyone written a Notepad ++ a G-code editor with the same colours?