Hello
Does anybody know where i can get programing manual for old EMA Cnc control that is on Promecam 2 axis upstroke machine.
In the attachment is the picture of numeric control.
Thanks...
Type: Posts; User: Cole84
Hello
Does anybody know where i can get programing manual for old EMA Cnc control that is on Promecam 2 axis upstroke machine.
In the attachment is the picture of numeric control.
Thanks...
Hello
I saw u mentioned something about motor jerks at startup. Startup machine move the motor 1/3 rd then alarm occurs then when u remove alarm can u move motor again in same direction, or he...
Hello!
I aint some expert but i think ur motor is bad.
Did u measure the ampers ( I ) that pass throw him. High amperes in stillstand position might mean that he is runing on two phases...
Hello,
Sorry to say but it looks like software interface problem. The machine should know what tool is in the machine, and in good software interface they block the exchange and even write either...
Did u write the name of program first like O1234 and then u have to press input. Then LSK is normal and when the program is over we also did get Alarm message 086 BP/S Alarm and when it appeared the...
When u fix ur port (mostly u need to replace a chip on board where rs232 port is connected because it got fried from high voltage that came throw ur computer ) or change to second one. U need to...
Hello!!
We have Pedersen VP-2000 with meldas 335M that has Floppy diskette on NC control unit. Our battery died (in transport) so our parameters are gone, we bought the parameters that came on...
Hello all we have STAR VNC-12 with Fanuc 3T and Fanuc MATE P MODEL B.
We losed parameters on MATE we can not read and modify parameters from number 35 to 90 and we can modify all others so if...
Hello !
Here is the list of alarms.
1.Are ur parameters inside drive OK ??
The 0000 means the drive is ready but it does not mean the parameters are right.
Do u have 4 buttons near display...
Hello.
The bigger problem is with our spindle. We can move all axis and we can change tools. But when we type M03 S100 in MDI mode the spindle starts to rotate and alarm 1007 trips that trip alarm...
Dear Chandu
I have been looking throw my books.
First look on ur orientation card and are there any led-diodes. There should be led-diode with name IN POSITION. So when u rotate spindle it should...
So these are the parameters for main spindle on A06B-6059-K0311.
Parameter- Data- Description
F00 0 Speed motor is dispayed
F01 ...
I solved my problem after i got parameters for my machine. The procedure of parameter input was just like DUKE356 told to do only i havent got jumper SET-DRIVE.
Many many thanks to GUHL and...
Thanks Guhul for nice parameter description. Will try them and i will report did i solve the problem.
Now Duke was right i initialize the memory but i didnt get any parameters with machine so i will try to contac machine dealer and try to get parameters. If anybody have parameter or parameters...
Thanks a lot m8 will try that :)
Nice explanation.
Hello!
We have COLCHESTER TORNADO 80 with GE-FANUC 21i-t
Ours backup battery died and when we replaced it and ater that we have problems
1.
When we are in MDI mode and when we enter M03 S500...
Hello all.
We have FANUC AC regulator for main spindle type A06B-6059-K0311.
On display we have error message AL-17.
Regulator has display on main board and 4 buttons
MODE UP...